6 Best Maintenance Suggestions For Your Car Battery
Your car battery is the heart of your car. Once it’s dead, your car won’t start. An environment-friendly (and also budget-friendly) thing you can do is to make the most of your battery and reduce the total number of batteries you will need during your lifetime. By visiting Roadside Response website at https://www.roadsideresponse.com.au/car-towing-services,you will come to know how you can do a lot of saving on this. Most motorists don’t know and also don’t care about maintaining their car batteries to let them last longer. Here are some car battery maintenance tips.
1. Find the Position of the Battery
For maintaining your car battery, you must know its position. Most of the car batteries are covered with a strong plastic case having two terminals to attach positive and negative (or ground) cables to the vehicle. The terminals usually look like two thimbles and are made of brass or lead. They can also be a pair of threaded screws or holes on the front side of the battery. Once you locate the battery and find all this structure, take a photo before you remove the cables, so that while connecting them again, you won’t reverse them.
2. Check Water Level
Car batteries are of two types: wet-cell battery and AGM or Absorbed Glass Matt battery. If you have an AGM battery, never try to open it. This is a maintenance-free battery and it’s a good idea to get its water levels checked by an expert. These batteries rarely need water. A wet-cell battery is non-maintenance-free and you can check its water level every 2-3 months. The water level should be such that it should just touch the bottom of the refill hole of the battery.
To check the fluid level, take out the battery’s fill caps. Some batteries are without fill caps because they are designed in such a way that they don’t need any water.
If the level is low, only distilled water should be used to refill the battery. Pour the water using a funnel. Wait till the water reaches the bottom of the refill hole. Take care not to overfill into the fill holes.
3. Clean the Terminals
You should clean the battery terminals every 6-8 months.
First detach the connectors by first moving them from side to side and then slowly pulling them up.
Make a paste of baking soda and distilled water. Rub a wire brush into it and gently rub over the terminals to remove dried buildup of acid and acquire a shine.
4. Protection from Rust and Corrosion
You can protect your battery from getting rusted and corroded by coating it with grease withstanding high temperatures.
5. Check Voltage
Don’t forget to check the voltage of your car battery every time your car goes for maintenance or you have an oil change. This will be done by your mechanic with a reliable method. The voltage of a fully charged battery should be 12.5 to 12.6 volts.
You can get the voltage checked from an auto parts shop between the visits to your regular mechanic. They charge for checking voltage. Remember that you should never test the battery when it’s under 12.5 volts until it achieves a fully charged level. When it’s not fully charged, the tester often shows ‘Bad Battery’ even if the battery is good.
6. Check Insulator
Some vehicles have an insulator to protect the battery from high temperatures, as high temperatures can quickly dry out battery’s fluid. Check the insulator if it’s in place and not damaged.
You should always be aware of your car’s battery. Aside from this, you also need to check that you can contact a company that offers roadside assist in Melbourne 24/7 by Roadside Response for help. Just keep their contact details handy along with you just in case you need to replace your car battery or you need an assistance from them.